to install the cover is equipped with if the accessory power socket connector and seat heater switch connectors are properly connected to confirm. No BOSE sound system puts the gloves to protect the note in your hands. Careful not hurting dashboards and related parts.

1. Write down the confirmation preset radio frequency identity theft prevention code [radio there. Remove the 2 dashboards Center low cover. 3 Removes the middle panel, and then remove the two mounting bolts. 4. Disconnect the audio unit connector (A) the antenna lead (B), hazard warning switch connector (C) removes audio unit the information avaliable here

Drive belt tension can be critical to the bearing life of the A/C compressor, alternator, etc. Tension should be checked and adjusted when a new belt is installed, and when a used belt is removed and reinstalled during a repair. For that reason, each Acura dealership is being sent a Belt Tension Gauge Set (T/N 07TGG-001000A). This set contains:
Belt tension gauge (T/N 07JGG-001010A)
Belt tension gauge extension cable
Belt tension gauge checker (T/N 07TGG-001010A)
Plastic pouch and instruction manual
Refer to the appropriate service manual for drive belt tension specifications and procedures.

CALIBRATION
The calibration of the belt tension gauge should be checked regularly. Use the Belt Tension Gauge Checker included in the Gauge Set. If needed, additional checkers may be ordered through normal parts ordering channels. The part number is 07TGG-001010A.
Procedure
1. Push the handle and slide the checker into the gauge. Position the checker as shown.
2. Release the handle and read the tension value on the Kg scale.
3. Compare your reading to the value etched on the checker. Your gauge is in calibration if it is within ±3 kg of the checker value.