Following Manual

Browse » home» 2819 » 2820 » and » hand » hydraulic » instruction » manual » pdf » pump » pumps » Hydraulic Pump 2819 and 2820 HYDRAULIC HAND PUMPS Instruction Manual

---

Hydraulic Pump 2819 and 2820 HYDRAULIC HAND PUMPS Instruction Manual

Internal parts of the pump are made of Buna-N rubber, aluminum, brass and stainless steel. The pump can be used with oil, water, or other compatible fluids. Use of water will accelerate wear of “O” rings and some sticking of piston may result. The recommended fluid is any petroleum based hydraulic oil, light weight motor oil or mineral oil. Do not use brake fluid or synthetic oils; they may crack the polycarbonate reservoir or cause swelling or decomposition of the “O” rings. To prevent damage to the pump and possible injury, never connect your pump to a pressure source greater than 35 MPa (5000 PSIG, 350 bar). Turn off, or isolate, all pressure-generating equipment from the pressure tap prior to connecting the pump. Your pump has two connections: A 1⁄4” female NPT pressure port for a reference gauge like an XP2i digital test gauge or 30 Series calibrator (figure 1) and a hose adapter with integral shutoff valve (figure 2). Always use PTFE (polytetrafluoro-ethylene) tape on the threads of any pressure fittings installed into the NPT port. Connect your reference gauge, or plug the 1⁄4” female NPT port prior to priming or using your pump. As for the hose connection, we offer a wide variety of conversion fittings to permit using the system with most commonly used fittings.

Download: Hydraulic Pump 2819 and 2820 HYDRAULIC HAND PUMPS Instruction Manual